TPS: FEEDING SYSTEM FAILURE indicates wire clogging or buckling in the feeding system, which may be resolved by inching retract or manual wire adjustment. The manual's first action is: “-The most problems automatically solve when inching retract is performed on the wire for a short time at the time of error reset. -If the problem persists, try to perform manual wire inching or wire retract. -Adjust manually the sensor of the wire buffer to the proper position. -If the problem frequently occurs, first check the feeding system for abnormally high feeding load, and replace parts as needed.”
- Model
- Yaskawa 2DX200
- Display shows
- TPS: FEEDING SYSTEM FAILURE (1111)
- Type
- Error code
- Source
- Manual p. 66
What 1111 means
TPS: FEEDING SYSTEM FAILURE p. 66
Common causes
- A wire was clogged or so in the feeding system, leading to improper feeding. For the CMT welding power source, the possibilities are high that the wire buckled in the wire buffer and this caused a problem with the sensor in the buffer. p. 66
What to do
- -The most problems automatically solve when inching retract is performed on the wire for a short time at the time of error reset. -If the problem persists, try to perform manual wire inching or wire retract. -Adjust manually the sensor of the wire buffer to the proper position. -If the problem frequently occurs, first check the feeding system for abnormally high feeding load, and replace parts as needed. p. 66
Before you service the product, read the safety instructions in the manual p. 2.
If 1111 is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about 1111; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.