Error code1110
TPS: SELECTED UNREGISTERED PROGRAM means a welding program not prepared for the power source was selected, requiring reselection of an appropriate program. The manual's first action is: “Select again a welding program.”
- Model
- Yaskawa 2DX200
- Display shows
- TPS: SELECTED UNREGISTERED PROGRAM (1110)
- Type
- Error code
- Source
- Manual p. 66
What 1110 means
TPS: SELECTED UNREGISTERED PROGRAM p. 66
Common causes
- A welding program unprepared for the welding power source was selected. p. 66
What to do
- Select again a welding program. p. 66
Before you service the product, read the safety instructions in the manual p. 2.
If 1110 is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about 1110; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.