Fault codeF7484
The axis moved outside the defined monitoring window after reaching a fixed stop. The manual's first action is: “• Check the monitoring window (p2635). • Check the mechanical system.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- EPOS: Fixed stop outside the monitoring window (F7484)
- Type
- Fault code
- Source
- Manual p. 295
What F7484 means
EPOS: Fixed stop outside the monitoring window p. 295
Common causes
- In the "fixed stop reached" state, the axis has moved outside the defined monitoring window (p2635). p. 295
What to do
- • Check the monitoring window (p2635). • Check the mechanical system. p. 295
Before you service the product, read the safety instructions in the manual p. 2.
If F7484 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7484; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.