Fault codeF7482
The axis position exceeds the software limit switch plus setting. The manual's first action is: “• Correct the target position. • Change software limit switch plus (Cl: p2581).”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- EPOS: Axis position > software limit switch plus (F7482)
- Type
- Fault code
- Source
- Manual p. 295
What F7482 means
EPOS: Axis position > software limit switch plus p. 295
Common causes
- The actual position of the axis is greater than the position of the software limit switch plus. p. 295
What to do
- • Correct the target position. • Change software limit switch plus (Cl: p2581). p. 295
Before you service the product, read the safety instructions in the manual p. 2.
If F7482 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7482; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.