Error codeF7011
Motor overtemperature due to overload, high ambient temperature, or sensor disconnection. The manual's first action is: “Reduce the motor load.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Motor overtemperature (F7011)
- Type
- Error code
- Source
- Manual p. 290
What F7011 means
Motor overtemperature p. 290
Common causes
- Motor overloaded p. 290
- Motor surrounding temperature too high p. 290
- Wire breakage or sensor not connected p. 290
- Motor temperature model incorrectly parameterized p. 290
Safety warnings — read before you start
- DANGERGeneral Safety Instructions. Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions. p. 2
- WARNINGRisk of Electric Shock and Fire. Risk of electric shock and fire from supply networks with an excessively low impedance Excessively high short-circuit currents can lead to the protective devices not being able to interrupt these short-circuit currents and being destroyed, and thus causing electric shock or a fire. p. 12
- WARNINGElectric Shock if No Ground Connection. Electric shock if there is no ground connection For missing or incorrectly implemented protective conductor connection for devices with protection class I, high voltages can be present at open, exposed parts, which when touched, can result in death or severe injury. p. 12
- WARNINGElectric Shock Due to Unsuitable Power Supply. Electric shock due to connection to an unsuitable power supply When equipment is connected to an unsuitable power supply, exposed components may carry a hazardous voltage that might result in serious injury or death. p. 12
What to do
- Reduce the motor load. p. 290
- Check the surrounding temperature and the motor ventilation. p. 290
- Check the wiring and the connection. p. 290
- Check the motor temperature model parameters. p. 290
If F7011 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7011; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.