Fault codeF1910
Setpoints from the fieldbus interface (Modbus/USS) were not received due to communication interruption. The manual's first action is: “Restore the bus connection and set the controller to RUN.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Fieldbus: setpoint timeout (F1910)
- Type
- Fault code
- Source
- Manual p. 289
What F1910 means
Fieldbus: setpoint timeout p. 289
Common causes
- The reception of setpoints from the fieldbus interface (Modbus/USS) has been interrupted. p. 289
What to do
- Restore the bus connection and set the controller to RUN. p. 289
Before you service the product, read the safety instructions in the manual p. 2.
If F1910 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F1910; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.