Error codeF7085
Control parameters have exceeded dynamic limits and are not usable because hardware lacks required features. The manual's first action is: “It is not necessary to change the parameters as they have already been correctly limited.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Open-loop/closed-loop control parameters changed (F7085)
- Type
- Error code
- Source
- Manual p. 290
What F7085 means
Open-loop/closed-loop control parameters changed p. 290
Common causes
- As a result of other parameters, they have exceeded the dynamic limits. p. 290
- They cannot be used due to the fact that the hardware detected not having certain features. p. 290
What to do
- It is not necessary to change the parameters as they have already been correctly limited. p. 290
Before you service the product, read the safety instructions in the manual p. 2.
If F7085 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7085; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.