Fault codeF52980
The servo motor with absolute encoder is changed. Actual motor ID is different from commissioned motor ID. The manual's first action is: “The servo motor will be automatically configured after the acknowledgement of this fault.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Absolute encoder motor changed (F52980)
- Type
- Fault code
- Source
- Manual p. 303
What F52980 means
Absolute encoder motor changed p. 303
Common causes
- The servo motor with absolute encoder is changed. Actual motor ID is different from commissioned motor ID. p. 303
What to do
- The servo motor will be automatically configured after the acknowledgement of this fault. p. 303
Before you service the product, read the safety instructions in the manual p. 2.
If F52980 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F52980; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.