Fault codeF31150
Encoder functionality is not operating correctly. The manual's first action is: “Check the encoder type used (incremental/absolute) and the encoder cable.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Initialization error (F31150)
- Type
- Fault code
- Source
- Manual p. 303
What F31150 means
Initialization error p. 303
Common causes
- Encoder functionality is not operating correctly. p. 303
What to do
- Check the encoder type used (incremental/absolute) and the encoder cable. p. 303
Before you service the product, read the safety instructions in the manual p. 2.
If F31150 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F31150; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.