Fault codeF52881
Connected absolute encoder motor cannot be operated. The servo drive in use does not support the Motor ID. The manual's first action is: “Use a suitable absolute encoder motor.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Absolute encoder motor mismatched (F52881)
- Type
- Fault code
- Source
- Manual p. 303
What F52881 means
Absolute encoder motor mismatched p. 303
Common causes
- Connected absolute encoder motor cannot be operated. The servo drive in use does not support the Motor ID. p. 303
What to do
- Use a suitable absolute encoder motor. p. 303
Before you service the product, read the safety instructions in the manual p. 2.
If F52881 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F52881; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.