Siemens G120C Error F30650: SI P2: Acceptance test required

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault codeF30650

Processor 2 of the drive’s Safety Integrated function requires an acceptance test to verify its operational integrity before resuming operation. The manual lists no action for this code.

Model
Siemens G120C
Display shows
SI P2: Acceptance test required (F30650)
Type
Fault code
Source
Manual p. 745

What F30650 means

SI P2: Acceptance test required p. 745

Common causes

  • The drive-integrated "Safety Integrated" function on processor 2 requires an acceptance test. p. 745
  • This fault results in a STOP A that can be acknowledged. p. 745
  • Fault value (r0949, interpret decimal): p. 745
  • 130: Safety parameters for processor 2 not available. p. 745
  • Note: p. 745
  • This fault value is always output when Safety Integrated is commissioned for the first time. p. 745
  • 1000: Reference and actual checksum on processor 2 are not identical (booting). p. 745
  • - at least one checksum-checked piece of data is defective. p. 745
  • - safety parameters set offline and loaded into the Control Unit. p. 745
  • 2000: Reference and actual checksum on processor 2 are not identical (commissioning mode). p. 745
  • 2003: Acceptance test is required as a safety parameter has been changed. p. 745
  • 2010: Enable of safety-related brake control between the two monitoring channels differ (p9602 not equal to p9802). p. 745
  • 9999: Subsequent response of another safety-related fault that occurred when booting that requires an acceptance test. p. 745

If F30650 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 745 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F30650; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.