Siemens G120C Error F30656: SI P2: Parameter processor 2 parameter error

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault codeF30656

An error occurred while accessing the Safety Integrated parameters for processor 2 in non-volatile memory, requiring acknowledgment before proceeding. The manual lists no action for this code.

Model
Siemens G120C
Display shows
SI P2: Parameter processor 2 parameter error (F30656)
Type
Fault code
Source
Manual p. 746

What F30656 means

SI P2: Parameter processor 2 parameter error p. 746

Common causes

  • When accessing the Safety Integrated parameters for the processor 2 in the non-volatile memory, an error has occurred. p. 746
  • Note: p. 746
  • This fault results in a STOP A that can be acknowledged. p. 746
  • Fault value (r0949, interpret decimal): p. 746
  • 129: Safety parameters for processor 2 corrupted. p. 746
  • 131: Internal software error on processor 1. p. 746
  • 255: Internal software error on processor 2. p. 746

If F30656 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 746 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F30656; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.