Siemens G120C Error F30649: SI P2: Internal software error

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault codeF30649

An internal software error has occurred within the Safety Integrated system on processor 2. The manual lists no action for this code.

Model
Siemens G120C
Display shows
SI P2: Internal software error (F30649)
Type
Fault code
Source
Manual p. 745

What F30649 means

SI P2: Internal software error p. 745

Common causes

  • An internal error in the Safety Integrated software on processor 2 has occurred. p. 745

If F30649 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 745 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F30649; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.