Siemens G120C Error F01910: Fieldbus interface setpoint timeout

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Alarm codeF01910

The fieldbus interface failed to receive setpoints, likely due to an interrupted bus connection or communication partner turning off. The manual's first action is: “See also: p2040 (Fieldbus interface monitoring time), p2047 (PROFIBUS additional monitoring time)”

Model
Siemens G120C
Display shows
Fieldbus interface setpoint timeout (F01910)
Type
Alarm code
Source
Manual p. 689

What F01910 means

Fieldbus interface setpoint timeout p. 689

Common causes

  • The reception of setpoints from the fieldbus interface has been interrupted. p. 689
  • - bus connection interrupted. p. 689
  • - communication partner switched off. p. 689
  • For PROFIBUS: p. 689

What to do

  1. See also: p2040 (Fieldbus interface monitoring time), p2047 (PROFIBUS additional monitoring time) p. 689

Before you service the product, read the safety instructions in the manual p. 4.

If F01910 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 689 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F01910; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.