Siemens CU240S Error F00060: Asic Timeout

Siemens CU240S · taken from the manufacturer’s manual, pages cited

Fault codeF00060

Asic Timeout indicates internal communications failure, possibly due to hardware or software link failures. The manual's first action is: “Check connection between inverter power module and inverter control unit”

Model
Siemens CU240S
Display shows
Asic Timeout (F00060)
Type
Fault code
Source
Manual p. 386

What F00060 means

Asic Timeout p. 386

Common causes

  • Internal communications failure p. 386
  • r0949 = 0: HW reported Link Fail p. 386
  • r0949 = 1: SW reported Link Fail p. 386
  • Communication failure due to EMC problems p. 386
  • Use EMC filter p. 386
  • Fault appears sporadically. p. 386
  • Fault appears immediately when mains voltage is applied and an ON command is given. p. 386

What to do

  1. Check connection between inverter power module and inverter control unit p. 386
  2. Check - and if necessary - improve EMC p. 386
  3. If fault persists, change inverter. p. 386
  4. Contact Service Department. p. 386

If F00060 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 386 All CU240S error codes Manual details & download

This page summarises what the manufacturer’s manual says about F00060; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.