Siemens CU240S Error F00056: BOP not fitted

Siemens CU240S · taken from the manufacturer’s manual, pages cited

Fault codeF00056

BOP not fitted indicates attempt to initiate parameter cloning without the BOP being installed. The manual's first action is: “Fit BOP and try again.”

Model
Siemens CU240S
Display shows
BOP not fitted (F00056)
Type
Fault code
Source
Manual p. 386

What F00056 means

BOP not fitted p. 386

Common causes

  • Trying to initiate parameter cloning without BOP fitted. p. 386

What to do

  1. Fit BOP and try again. p. 386

If F00056 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 386 All CU240S error codes Manual details & download

This page summarises what the manufacturer’s manual says about F00056; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.