Drive attempted to do an automatic clone during startup indicates no Clone00.bin file is present in the correct directory. The manual's first action is: “If a automatic clone is required: - Insert MMC with correct File anc power cycle. If no automatic clone is required: - Remove MMC if not needed and power cycle. - Reset P8458 = 0 and power cycle.”
- Model
- Siemens CU240S
- Display shows
- Drive attempted to do an automatic clone during startup. (F00064)
- Type
- Fault code
- Source
- Manual p. 387
What F00064 means
Drive attempted to do an automatic clone during startup. p. 387
Common causes
- No Clone00.bin File in the correct directory /USER/SINAMICS/DATA. p. 387
What to do
- If a automatic clone is required: - Insert MMC with correct File anc power cycle. If no automatic clone is required: - Remove MMC if not needed and power cycle. - Reset P8458 = 0 and power cycle. p. 387
If F00064 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.
This page summarises what the manufacturer’s manual says about F00064; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.