A minor bit fault (bits 0,...7) in S:5 was set at the end of scan. The manual's first action is: “['Correct the instruction logic causing the error.', 'Enter the status file display in your programming software and clear the fault.', 'Enter the Run mode.']”
- Model
- Rockwell Automation MicroLogix 1400
- Display shows
- MINOR ERROR AT END-OF-SCAN DETECTED (0020)
- Type
- Error code
- Source
- Manual p. 403
What 0020 means
MINOR ERROR AT END-OF-SCAN DETECTED p. 403
Common causes
- A minor bit fault (bits 0,...7) in S:5 was set at the end of scan. p. 403
What to do
- ['Correct the instruction logic causing the error.', 'Enter the status file display in your programming software and clear the fault.', 'Enter the Run mode.'] p. 403
Before you service the product, read the safety instructions in the manual p. 274.
If 0020 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.
This page summarises what the manufacturer’s manual says about 0020; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.
