Rockwell Automation MicroLogix 1400 Error 0017: NVRAM/MEMORY MODULE USER PROGRAM MISMATCH

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0017

Memory module user program does not match controller user program, as indicated by bit S:2/9 being set. The manual's first action is: “Transfer the memory module program to the controller and then change to Run mode.”

Model
Rockwell Automation MicroLogix 1400
Display shows
NVRAM/MEMORY MODULE USER PROGRAM MISMATCH (0017)
Type
Error code
Source
Manual p. 403

What 0017 means

NVRAM/MEMORY MODULE USER PROGRAM MISMATCH p. 403

Common causes

  • Bit S:2/9 is set in the controller and the memory module user program does not match the controller user program. p. 403

What to do

  1. Transfer the memory module program to the controller and then change to Run mode. p. 403

Before you service the product, read the safety instructions in the manual p. 274.

If 0017 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0017; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.