Rockwell Automation MicroLogix 1400 Error 0015: I/O CONFIGURATION FILE ERROR

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0015

User program I/O configuration file is invalid. The manual's first action is: “Recompile and reload the program, and enter the Run mode. If the error persists, be sure to use RSI programming software to develop and load the program.”

Model
Rockwell Automation MicroLogix 1400
Display shows
I/O CONFIGURATION FILE ERROR (0015)
Type
Error code
Source
Manual p. 402

What 0015 means

I/O CONFIGURATION FILE ERROR p. 402

Common causes

  • The user program I/O configuration is invalid. p. 402

What to do

  1. Recompile and reload the program, and enter the Run mode. If the error persists, be sure to use RSI programming software to develop and load the program. p. 402

Before you service the product, read the safety instructions in the manual p. 274.

If 0015 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0015; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.