Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The EEV backup voltage alarm indicates that the backup power supply for the EEV is not functioning correctly. The manual lists no action for this code.
The EEV low suction temperature alarm indicates that the suction pressure or temperature has dropped below acceptable levels. The manual lists no action for this code.
The EEV Driver offline alarm indicates that the driver controlling the EEV is not communicating properly. The manual lists no action for this code.
The EEV motor alarm (open / short circuit wire) indicates that there is a fault in the EEV motor wiring, either open or shorted. The manual lists no action for this code.
The EEV EEPROM alarm indicates a problem with the internal memory of the EEV controller. The manual lists no action for this code.
The EEV Hi Condensing Temperature (HiTcond) alarm indicates that the condenser temperature is too high for the EEV to handle. The manual lists no action for this code.
The EEV High evaporation temperature (MOP) alarm indicates that the evaporator temperature has risen above acceptable levels. The manual lists no action for this code.
The EEV Low evaporation temperature (LOP) alarm indicates that the evaporator temperature has dropped below acceptable levels. The manual lists no action for this code.
The EEV low SuperHeat alarm indicates that the superheat level is too low for the EEV to operate properly. The manual lists no action for this code.
The EEV probe S2 alarm indicates a problem with the S2 probe of the EEV. The manual lists no action for this code.
An EEV probe S1 alarm indicates an issue with the first evaporator valve position sensor. The manual lists no action for this code.
A general alarm has been activated without a specific cause identified. The manual lists no action for this code.
A condenser fan overload alarm has been triggered due to excessive load on the fan. The manual's first action is: “Auto”
Operating limits have been exceeded, triggering an operating limits exceeded alarm. The manual's first action is: “Manual”
An analogue input B4 alarm indicates an issue with the fourth external sensor input. The manual's first action is: “Manual”