Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Error 3: Watchdog fail indicates a system timeout or failure in monitoring the controller's operation. The manual's first action is: “Return the controller for repair”
Error 2 indicates a RAM self-test failure in the controller. The manual's first action is: “Return the controller for repair”
Error 1 indicates a failure in the ROM self-test. The manual's first action is: “Return the controller for repair”
The display is showing a value outside its configured range, indicating a high reading. The manual's first action is: “Check the value of the display range”
The display reading is outside its configured range and too low. The manual's first action is: “Check the value of the display range”
Remote input failure due to open circuit on the PDSIO® input The manual's first action is: “Check for open or short circuit wiring on the PDSIO® input”
Hardware error indicates a module is of the wrong type, missing or faulty. The manual's first action is: “Check that the correct modules are fitted.”
Heater failure alarm indicates a fault in the heating circuit. The manual's first action is: “This is an alarm generated by feedback from a Eurotherm TE10S solid state relay (SSR) operating in PDSIO® SSRx Enhanced Loa…
A solid state relay failure alarm is generated by feedback from a TE10 SSR in PDSIO® SSRx Enhanced Load Doctor mode. The manual's first action is: “This is an alarm generated by feedback from a Eurotherm TE10S solid s…
Load failure code l.dF indicates a fault in the heating circuit or solid state relay. The manual's first action is: “This is an alarm generated by feedback from a Eurotherm TE10S solid state relay (SSR) operating in P…
The feedback loop is open circuit. The manual's first action is: “Check that the heating and cooling circuits are working properly.”
Sensor Break: Input sensor is unreliable or the input signal is out of range. The manual's first action is: “Check that the sensor is correctly connected.”
Electrically Erasable Memory Error indicates a corrupted operator or configuration parameter value. The manual's first action is: “This fault will automatically take you into configuration level. Check all of the conf…
All 21 error codes of the Eurotherm 2216e Eurotherm 2216e controller with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Unable to receive the next-page data. The manual lists no action for this code.