Error Codes

Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 15: Invalid Control

  An invalid control byte is included with the Smart transmitter Interface command. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 14: Invalid Parameter

  An invalid parameter is provided with the Smart Transmitter Interface command and so it cannot be processed. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 13: Invalid Channel List

  The channel list provided with the Enable Burst Monitor Mode command contains an invalid entry or is incorrectly terminated. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 12: Invalid HART Message

  The HART packet encapsulated within a Smart Transmitter Interface is invalid and cannot be forwarded to a field device. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 11: Invalid Channel Number

  The Smart Transmitter Interface channel number is invalid and the command cannot be processed. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 10: Invalid Command

  The Smart Transmitter Interface command is invalid and cannot be processed. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 03: Command Still in Progress

  The Smart Transmitter Interface is still attempting to obtain a field device response. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 02: No Corresponding BTW

  The Smart Transmitter Interface received a BTR but does not know what data is being requested. The manual lists no action for this code.

• CodeAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error 01: Downloading Firmware

  The Smart Transmitter Interface firmware is being upgraded over the RS-232C port and cannot process the last received command. The manual lists no action for this code.

• Code listAllen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Error Codes

  All 13 error codes of the Allen-Bradley 1770-HT1, 1770-HT8, 1770-HT16 Smart Transmitter Interface with their meaning, causes and what to do, taken from the manufacturer's manual with page references.

• CodeEurotherm 2216e Error S5rF: SSR Fail

  SSR Fail indicates a solid state relay has failed while the controller output demand signal is off. The manual lists no action for this code.

• CodeEurotherm 2216e Error HrF: Heater Fail

  Heater Fail code HrF indicates no current is being drawn while the controller output demand signal is on. The manual lists no action for this code.

• CodeEurotherm 2216e Error LdF: Load Fail

  Load Fail code indicates a failure in the heater circuit or SSR. The manual lists no action for this code.

• CodeEurotherm 2216e Error -HCr: High Current

  High Current code indicates load overcurrent protection has been triggered. The manual lists no action for this code.

• CodeEurotherm 2216e Error -LCr: Low Current

  Low Current indicates a partial load failure detection. The manual lists no action for this code.