Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The hot water tank thermostat is active during the wash programme. The manual's first action is: “Contact your HOBART Service Partner.”
The boiler sensor detected a temperature that was too low. The manual's first action is: “Contact your HOBART Service Partner.”
The boiler sensor detected a temperature that exceeded its safe limit. The manual's first action is: “Contact your HOBART Service Partner.”
All 17 error codes of the Hobart Ecomax / Ecomax+ H604 / H614 / H615 dishwasher with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Maintenance is demanded for this unit. The manual lists no action for this code.
Bus error at the third interface (X3) has been detected. The manual lists no action for this code.
Bus error at the second interface (X2) has been detected. The manual lists no action for this code.
Bus error at the first interface (X1) has been detected. The manual lists no action for this code.
Hardware fault or software error has occurred. The manual lists no action for this code.
All 5 error codes of the Siemens CPU 31xC / CPU 31x Siemens CPU 31xC / CPU 31x with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Parameter fault P211/P212 indicates an invalid setting where P211 is not less than P212. The manual's first action is: “Set parameter P211 < P212.”
P006 = 1 while P201 = 2 indicates a conflict between parameter settings for fixed frequency and motor potentiometer control modes. The manual's first action is: “Change parameter P006 and/or P201.”
Automatic calibration failure occurs when the motor is not connected to the inverter, requiring manual entry of stator resistance if the issue persists after reconnection. The manual's first action is: “Motor not conn…
Digital input parameter fault indicates that digital inputs P052–P055 are misconfigured and require correction of their settings. The manual's first action is: “Change the settings of digital inputs P052 to P055.”
Digital input parameter fault indicates that digital inputs P052–P055 are misconfigured and require correction of their settings. The manual's first action is: “Change the settings of digital inputs P052 to P055.”