Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Target node does not respond indicates no response from the target node, possibly due to hardware or communication issues. The manual lists no action for this code.
Target node cannot respond because requested function is not available means the target node does not support the requested operation. The manual lists no action for this code.
Local processor is offline (possible duplicate node situation) indicates the local processor has disconnected, possibly due to a duplicate node configuration. The manual lists no action for this code.
Target node cannot respond because it does not understand command parameters or a control block was modified means the command is invalid or misconfigured. The manual lists no action for this code.
Target node cannot respond because message is too large indicates the message size exceeds the target node’s capacity. The manual lists no action for this code.
Target node is busy, NAK No Memory retries by link layer exhausted means the target node is unresponsive due to being busy or memory exhaustion. The manual lists no action for this code.
ERR_QUE_FULL indicates a communications channel configuration change while an instruction was running or an invalid family in the service parameter. The manual's first action is: “None required,”
INVALID_TYPE_CODE signifies an ACL instruction closure due to an invalid type code in the service parameter. The manual's first action is: “None required,”
INVALID_SERVER_TYPE means the control field length is invalid or the server type in the service parameter is incorrect. The manual's first action is: “Enter a valid length and retry operation.”
ERR_SOCKET_DELETE occurs when the source string length is invalid or there's a socket type error during deletion. The manual's first action is: “Enter a valid string length and retry operation,”
ERR_SOCKET_DISCONNECT indicates an invalid service code or socket error during a disconnect operation. The manual's first action is: “Enter a valid string length and retry operation,”
The unload bit is set, stopping instruction execution due to invalid data size in the MS6 instruction. The manual's first action is: “None required,”
Requested ASCII operation is unsupported by channel configuration or a file write attempt was made on a read-only file. The manual's first action is: “Reconfigure the channel and retry operation.”
An ASCII transmission is already in progress or invalid Modbus address was accessed, preventing instruction execution. The manual's first action is: “Resend the transmission,”
The scaled setpoint minimum exceeds the maximum, requiring adjustment to correct the range. The manual's first action is: “Change scaled setpoint min MinS to -32768 ≤ MinS ≤ +32767”