Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Message timed out in local processor. The manual lists no action for this code.
PCCC Description: Remote station host is not there, disconnected, or shutdown. The manual lists no action for this code.
Bad MSG file parameter for building message. The manual lists no action for this code.
PCCC Description: Host has a problem and does not communicate. The manual lists no action for this code.
Broadcast is not supported. The manual lists no action for this code.
Local service is not supported. The manual lists no action for this code.
Target or Local Bridge address is higher than maximum node address indicates an address exceeds the system’s maximum allowable limit. The manual lists no action for this code.
Local channel configuration parameter error exists means a parameter in the local channel configuration is invalid or improperly set. The manual lists no action for this code.
Local MSG configuration error in the Remote MSG parameters indicates misconfiguration of remote message parameters on the local side. The manual lists no action for this code.
Local channel configuration protocol error exists indicates a problem with the local channel’s communication protocol settings. The manual lists no action for this code.
Target node cannot respond because of incorrect command parameters or unsupported command means the command sent is invalid or not supported by the target node. The manual lists no action for this code.
DCOMM button was activated while an ASCII instruction was waiting to execute indicates an attempt to activate DCOMM during an ongoing ASCII command. The manual lists no action for this code.
Received a master link reset (one possible source is from the DF1 master) means a master link reset occurred, possibly initiated by the DF1 master. The manual lists no action for this code.
Target node does not accept this type of MSG instruction indicates the target node rejects the message type being sent. The manual lists no action for this code.
Target node does not respond or local modem connection has been lost means either the target is unresponsive or the modem link failed. The manual lists no action for this code.