Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Overcurrent protection The manual's first action is: “p.6-9”
Overcurrent protection The manual's first action is: “p.6-9”
The inverter enters Alarm mode if the protection function is activated. The manual lists no action for this code.
The output current drops below the operation level set by Overload Early Warning/Current Detection/Low Current Detection (E34: Level) for a duration longer than specified by Current Detection/Low Curr The manual lists…
The output current exceeds the operation level set by Overload Early Warning/Current Detection/Low Current Detection (E34: Level) for a duration longer than specified by Current Detection/Low Current. The manual lists…
The overload prevention function is activated if the frequency drop rate exceeds the setting specified by function code H70. The minimum ON-duration is 100 ms. The manual lists no action for this code.
The motor is driven by the frequency higher than the starting frequency or DC braking is activated. The manual lists no action for this code.
All 26 error codes of the Fuji Electric FRENIC-Mini FRENIC-Mini inverter with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
E9999 is a system error with no specific cause, directing users to consult "When error cannot be resolved." The manual lists no action for this code.
E0500 indicates that a version upgrade has already been completed, and the tool execution must be restarted as per instructions. The manual lists no action for this code.
E0400 appears if the version of the updated SRDM or the copy being updated is not supported by the DB update tool. The manual lists no action for this code.
E0301 occurs when the data folder subdirectory for the relevant SRDM environment is empty. The manual lists no action for this code.
E0300 indicates that the "BaseX.jar" data file is missing from the same location as the updated SRDM copy, or the data folder is not present in the relevant environment. The manual lists no action for this code.
E0201 appears if the BaseX lib folder for either the updated SRDM or the update file cannot be found. The manual lists no action for this code.
E0200 occurs when the BaseX.jar file is missing from the same location as the updated SRDM copy. The manual lists no action for this code.