Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The platform OS recovery process was started by the firmware. The manual's first action is: “Platform recovery started”
All 32 error codes of the HP Sure Recover HP Sure Recover with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Encoder2 POS difference error is reserved and not described. The manual lists no action for this code.
Excessive SPD deviation from motor cable, encoder cable, or parameter issues. The manual's first action is: “Disconnect, wiring is incorrect and check Short. Replace motor cable”
POS following error caused by parameter settings on [0x6091], [0x8086], or [0x8065]. The manual's first action is: “Check setting value [0x3000], [0x3003], [0x3004]. Set up correct parameter according to operating met…
Over speed limit error due to motor encoder fault, cable issue, or parameter misconfiguration. The manual's first action is: “Wiring is incorrect and check Short. Replace motor cable.”
Control power fail from voltage mismatch between C1/C2 phases or drive malfunction. The manual's first action is: “Recheck power supply of drive”
Main power fail caused by incorrect voltage, parameter error, or momentary power loss. The manual's first action is: “check voltage between phase 200-230[Vac] of L1, L2, L3”
Over voltage condition due to high main power input, braking resistor issue, or acceleration/deceleration settings. The manual's first action is: “Check whether the main power voltage is below 253[Vac]”
Under voltage condition from low main power input or running at insufficient voltage. The manual's first action is: “Check the main power voltage is over 3phase 134[Vac]”
Z phase open error caused by motor/drive combination failure, encoder cable issue, or encoder malfunction. The manual's first action is: “Check brand label code of motor and drive.”
Sinusoidal ENC frequency issue due to parameter error, drive problem, or resolver fault. The manual's first action is: “Check setting valud of encoder type [0x2001]”
Sinusoidal ENC error from faulty encoder cable connections. The manual's first action is: “Wiring Is Incorrect and check short Check shield and FG disconnect”
Low battery condition caused by parameter error, disconnected battery, or low voltage. The manual's first action is: “Check settting value [0x2005]”
Encoder setting error due to incorrect wiring, encoder malfunction, or drive issue. The manual's first action is: “Wiring Is Incorrect and check Short. Replace encoder cable.”