Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A software operation error occurred in the CIP server task request data. The manual's first action is: “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and…
An error occurred in receiving mail from the CIP server task. The manual's first action is: “(1)Reset the alarm., and then try again. (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then conta…
The fan fuse has failed. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, check if there is a ground fault or short circuit in the fan power line.”
The maximum torque has not been detected on an axis. The manual's first action is: “Set a large value for the BASIC T, and then check again.”
The axis did not reach the specified basic speed. The manual's first action is: “Increase the speed specification value of a measurement job or set a small value for BASICV. Or set a small value for BASIC T, or length…
The sample buffer has overflowed on an axis. The manual's first action is: “Shorten the measurement section.”
The system detected insufficient sample data for an axis. The manual's first action is: “Lengthen the measurement section.”
The SETPRM instruction attempted to change a parameter not related to the cube. The manual's first action is: “(1)Check the following settings. - The SETPRM instruction cannot change the parameter values other than th…
The system attempted to read a register that does not exist. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact…
The SETREG instruction attempted to change a register value currently in use by TMR/CNT. The manual's first action is: “(1)Check the following settings. - The SETREG instruction cannot change the register values used …
A software operation error occurred in torque measurement mode. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then cont…
A software operation error occurred in TRQ MEASURE MODE SET ERROR(SV) The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and the…
The macro job execution has failed due to incorrect settings. The manual's first action is: “(1)Check the following settings. -Check the settings for execution macro job.”
A software operation error occurred that lacks global variable area. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then…
A setting error has occurred in the tool data configuration. The manual's first action is: “(1)Check the following settings. -Correct the job so that the setting value of tag is allowable value. -Set the allowance amo…