Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Setting Motor ID The manual's first action is: “Value of [0x2000] is same with application motor label.”
Encoder error The manual's first action is: “If alarm continue after servo on again, Replace drive. Because drive may have problem.”
Parameter setting error The manual's first action is: “Value of [0x2001], [0x2002] is same with application motor label.”
Encoder cable error The manual's first action is: “Disconnect, wiring is incorrect and check Short.”
Reserved The manual lists no action for this code.
Surrounding temperature, Drive error The manual's first action is: “Check whether surrounding temperature is over 50[°C]”
Drive error, In case of sequent operating that exceed rated load, Motor brake error The manual's first action is: “Check if load which is accumulating driving load rate[0x2603] is below 100% when it is in constant spe…
Motor U/V/W phase current offset oversetting The manual's first action is: “Check whether the U/V/W phase current offset [0x2015~0x2017] are 5% of the rated current or highter.”
Surroundings temperature, Continuous Overload alaram, Motor cable open The manual's first action is: “Check whether surrounding temperature is over 50 [C]”
Drive error, Error by noize The manual's first action is: “Determine whether there is a conflict or binding in the equipment.”
Parameter cable error, Check motor phase resistor The manual's first action is: “Motor ID [0x2000], encoder type[0x201], encoder form[0x202] setting vaule should be same with applied to motor label.”
Motor cable error, Encoder cable error The manual's first action is: “Wiring is incorrect and check short”
Check emergency stop contact signal, external 24V power The manual's first action is: “Check emergency stop contact signal, external 24V power”
The main power input voltage is under 190V when the action in case of main power fail is set to warning in the main power input mode setting (0x2006). The manual's first action is: “The main power input voltage is und…
Motor's current capacity is bigger than the drive's current capacity The manual's first action is: “Motor's current capacity is bigger than the drive's current capacity”