Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Code 25 flashes after code 13, followed by any current diagnostic codes. The manual lists no action for this code.
Code 13 may flash to indicate history codes are stored in the system. The manual lists no action for this code.
A malfunction has occurred with the 3rd gear oil pressure sensor, indicated after code 12. The manual lists no action for this code.
Code 12 always flashes first, followed by any current diagnostic codes. The manual lists no action for this code.
The rear ABS indicator lamp or brake lamp is flashing due to a fault in the braking system. The manual's first action is: “With the key on, momentarily connect and disconnect terminals 12 and 4 on the OBD-II 16-pin DL…
The ABS system has detected an error, indicated by the warning lamp staying on for 2 seconds then turning off and flashing stored codes during ignition cycles. The manual's first action is: “Short the service check co…
The ABS warning lamp is indicating a fault that requires reading diagnostic codes. The manual's first action is: “Short the service check connector and turn the ignition switch on, but do not start the engine. The ABS…
All 31 error codes of the Snap-on EAZ0025B02B diagnostic tool software with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Forward or reverse rotation limit abnormal occurs when either the forward limit switch or reverse limit button is pressed on this Shihlin Electric SDA Series product. The manual's first action is: “Alarm cleared after…
Emergency stop has been triggered by pressing the emergency stop switch on this Shihlin Electric SDA Series product. The manual's first action is: “Alarm cleared after eliminating possible causes”
Abnormal fan is detected on this Shihlin Electric SDA Series product. The manual's first action is: “Power OFF→ON”
Abnormal motor matching occurs when the capacity of the motor and actuator does not match well on this Shihlin Electric SDA Series product. The manual's first action is: “Power OFF→ON”
Position detector abnormal 2 occurs on this Shihlin Electric SDA Series product. The manual's first action is: “Power OFF→ON”
AL.0B means the position detector has an abnormal condition. The manual's first action is: “Power OFF→ON”
AL.08 indicates a large position control command due to improper acceleration/deceleration, torque restriction, or gain setup. The manual's first action is: “Power OFF→ON”