Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A1 indicates a low voltage condition from a previous AL02 alarm. The manual lists no action for this code.
A0 shows that AL01 alarm occurred previously. The manual lists no action for this code.
AL01 indicates the main loop input voltage is higher than the rated permissive voltage or there's an incorrect power source system. The manual's first action is: “Screen flickers when abnormal alarm happens.”
All 25 error codes of the Shihlin Electric SDA Series AC servo system with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
(Under Range) - OR (Over Range) The manual lists no action for this code.
An error condition exists or the incorrect key is pressed. The manual lists no action for this code.
All 2 error codes of the Thermo Fisher 150 & 450 Series waterproof handheld meter with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
A Device Failed error occurred in the PCOM block. The manual lists no action for this code.
An Interlocked condition occurred in the PCOM block. The manual lists no action for this code.
Flash Memory burn failed. The manual lists no action for this code.
A Cycle Time Overrun occurred – see STATN block – add Cycle Time bias. The manual lists no action for this code.
A Watchdog Timeout occurred. The manual lists no action for this code.
The LonWorks circuit board installed is not compatible with the configuration on the Board. The manual's first action is: “1) Power down and install the LonWorks board from the same controller that the Board came from.”
The controller powered down with a Board installed but could not identify it upon startup. The manual's first action is: “1) Install a Board or new Board.”
The Board's configuration is incompatible with the MPU Controller board database. The manual's first action is: “1) Install MPU firmware compatible with the Board configuration”