Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
AL.07 means the pulse command frequency exceeds rated input or the device is broken. The manual's first action is: “Power OFF→ON”
AL.06 indicates overspeed from high pulse frequency, improper acceleration/deceleration time, or servo instability. The manual's first action is: “Power OFF→ON”
AL.05 means overload occurred due to exceeding rated load, incorrect parameter setup, or system instability. The manual's first action is: “Power OFF→ON”
AL.03 shows the main loop current exceeds 1.5 times the motor’s instantaneous maximum current. The manual's first action is: “Power OFF→ON”
AL.04 indicates an abnormal regeneration condition. The manual's first action is: “Power OFF→ON”
AL.02 means main loop input voltage is too low or there's no input voltage source or incorrect power system. The manual's first action is: “Power OFF→ON”
AL.10 indicates a malfunction in the power transistor due to mechanical impacts, motor connection error, or vibration. The manual's first action is: “Power OFF→ON”
AL.0F shows an abnormal memory condition. The manual's first action is: “Power OFF→ON”
AL.0E means the transistor execution took longer than expected. The manual's first action is: “Power OFF→ON”
AL.0A indicates no communication commands were received for too long or the overtime constant is improperly set. The manual's first action is: “Power OFF→ON”
AL.09 means there's an error in the communication protocol setup causing serial communication failure. The manual's first action is: “Power OFF→ON”
A5 indicates a speed issue from a previous AL06 alarm. The manual lists no action for this code.
A4 shows that AL05 overload happened previously. The manual lists no action for this code.
A3 indicates an abnormal rebound after the last AL04 alarm occurred. The manual lists no action for this code.
A2 shows the current value from a previous AL03 alarm. The manual lists no action for this code.