Mitsubishi Electric MDS-C1 Series Error 8B: Encoder converter unit 2 automatic adjustment error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code8B

Encoder converter unit 2 automatic adjustment error means an abnormal signal from the PLG was detected during automatic adjustment, or a connector is disconnected or not disconnected. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Encoder converter unit 2 automatic adjustment error (8B)
Type
Error code
Source
Manual p. 313

What 8B means

Encoder converter unit 2 automatic adjustment error p. 313

Common causes

  • An abnormal signal from the PLG was detected during automatic adjustment of the PLG. p. 313
  • The connector is disconnected (or loose). p. 313
  • The connector is not disconnected. p. 313
  • There is a connection fault. p. 313
  • There is a problem. (The A/B phase input voltage is 0.8V or less or 2.2V or higher.) p. 313
  • Normal p. 313
  • Occurs each time. p. 313
  • Occurs occasionally. p. 313

What to do

  1. PR p. 313
  2. Correctly install. p. 313
  3. Investigate item 2. p. 313
  4. Replace the detector cable. p. 313
  5. Adjust the PLG output waveform. p. 313
  6. Investigate item 4. p. 313
  7. Replace the MDS-B-PJEX unit. p. 313
  8. Check whether the cable is disconnected, whether there is a contact fault, or a detector fault. p. 313

Before you service the product, read the safety instructions in the manual p. 4.

If 8B is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 8B; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.