Mitsubishi Electric MDS-C1 Series Error 90: Detector, initial communication error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Warning code90

Detector, initial communication error means initial communication with the absolute position linear scale was not possible or setting is incorrect. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Detector, initial communication error (90)
Type
Warning code
Source
Manual p. 314

What 90 means

Detector, initial communication error p. 314

Common causes

  • Initial communication with the absolute position linear scale was not possible. p. 314
  • The setting is incorrect. p. 314
  • The setting is correct. p. 314
  • The connector is disconnected (loose). p. 314
  • The connector is not disconnected. p. 314
  • The connection is faulty. p. 314
  • The connection is normal. p. 314
  • No abnormality is found in particular. p. 314
  • An abnormality was found in the ambient environment. p. 314

What to do

  1. PR p. 314
  2. Correctly set SV025. p. 314
  3. Investigate item 2. p. 314
  4. Correctly install. p. 314
  5. Investigate item 3. p. 314
  6. Replace the detector cable (CN3 side). p. 314
  7. Investigate item 4. p. 314
  8. Replace the tool end detector. (With the absolute position system, the zero point must be established.) p. 314
  9. Take remedies according to the causes of the abnormality. Ex. High temperature: Check the cooling fan. Incomplete grounding: Additionally ground. p. 314

Before you service the product, read the safety instructions in the manual p. 4.

If 90 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 90; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.