Mitsubishi Electric MDS-C1 Series Error 91: Detector, communication error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Warning code91

Detector, communication error means an error was detected in communication with the detector for absolute position detection system, or connector is disconnected or not disconnected. The manual's first action is: “*”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Detector, communication error (91)
Type
Warning code
Source
Manual p. 314

What 91 means

Detector, communication error p. 314

Common causes

  • An error was detected in the communication with the detector for the absolute position detection system. p. 314
  • The connector is disconnected (or loose). p. 314
  • The connector is not disconnected. p. 314
  • The cables are wired near each other. (Noise is entering from the power cable.) p. 314
  • The wires are sufficiently separated. p. 314
  • The motor FG wire is grounded on the motor side. p. 314
  • There is a connection fault. p. 314
  • The connection is normal. p. 314
  • The alarm is on the drive unit side. p. 314
  • The alarm is on the detector side. p. 314
  • No abnormality is found in particular. p. 314
  • An abnormality was found in the ambient environment. p. 314

What to do

  1. * p. 314
  2. Correctly install. p. 314
  3. Investigate item 2. p. 314
  4. Improve the cable wiring. p. 314
  5. Investigate item 3. p. 314
  6. Ground the motor to one point, connecting the wires together on the drive unit side. p. 314
  7. Investigate item 4. p. 314
  8. Replace the detector cable. p. 314
  9. Investigate item 5. p. 314
  10. Investigate item 6. p. 314
  11. Replace the detector. (With the absolute position system, the zero point must be established.) p. 314
  12. Take remedies according to the causes of the abnormality. Ex. High temperature: Check the cooling fan. Incomplete grounding: Additionally ground. p. 314

Before you service the product, read the safety instructions in the manual p. 4.

If 91 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 91; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.