The system has not received the tool post’s reverse locking signal within the tool post reverse locking time. The manual's first action is: “According to TCP input state of parameter NO.1 Bit7, check whether the setting of NO.9 Bit0 is correct.”
- Model
- GSK GSK980TB3
- Display shows
- 186
- Type
- Alarm code
- Source
- Manual p. 270
What 186 means
Tool post CW rotation locking signal is not received in the time of tool post CW rotation locking time. p. 270
Common causes
- Tool post CW rotation locking signal is not received in the time of tool post CW rotation locking time. p. 270
What to do
- According to TCP input state of parameter NO.1 Bit7, check whether the setting of NO.9 Bit0 is correct. p. 270
If 186 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.
This page summarises what the manufacturer’s manual says about 186; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.