Alarm 185 occurs when tool changing time exceeds set limit and tool position signal is not received. The manual's first action is: “According to input state of NO.2 T01-T08, check whether the setting of NO.9 Bit1 is correct or adjust P82 tool changing time.”
- Model
- GSK GSK980TB3
- Display shows
- 185
- Type
- Alarm code
- Source
- Manual p. 270
What 185 means
Time for tool setting is too long. Specified tool arrival signal has not been received Ta time after the start of tool CCW rotation. Alarm occurs. p. 270
Common causes
- Time for tool setting is too long. Specified tool arrival signal has not been received Ta time after the start of tool CCW rotation. Alarm occurs. p. 270
What to do
- According to input state of NO.2 T01-T08, check whether the setting of NO.9 Bit1 is correct or adjust P82 tool changing time. p. 270
If 185 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.
This page summarises what the manufacturer’s manual says about 185; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.