GSK GSK980TB3 Error 171: Spindle enable signal is not received

GSK GSK980TB3 · taken from the manufacturer’s manual, pages cited

Alarm code171

The spindle enable signal is not being received. The manual's first action is: “Check SPEN input state of parameter NO.3, and check whether circuit of the external spindle enable signal is normal, or change parameter NO.15 Bit1 to 0: detection for spindle enable signal is shielded.”

Model
GSK GSK980TB3
Display shows
Spindle enable signal is not received (171)
Type
Alarm code
Source
Manual p. 270

What 171 means

Spindle enable signal is not received p. 270

Common causes

  • Spindle enable signal is not received. p. 270

What to do

  1. Check SPEN input state of parameter NO.3, and check whether circuit of the external spindle enable signal is normal, or change parameter NO.15 Bit1 to 0: detection for spindle enable signal is shielded. p. 270

If 171 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 270 All GSK980TB3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 171; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.