M41-M44 cannot be used when spindle is in gear control or automatic gearing is inactive. The manual's first action is: “Requirements for using M41-M44: frequency conversion and spindle automatic gearing is active. Change parameter NO.1 Bit4 and NO.10 Bit7 to 1.”
- Model
- GSK GSK980TB3
- Display shows
- 180
- Type
- Alarm code
- Source
- Manual p. 270
What 180 means
M41~M44 can not be used when spindle is in gear control or spindle automatic gearing is inactive. p. 270
Common causes
- M41~M44 can not be used when spindle is in gear control or spindle automatic gearing is inactive. p. 270
What to do
- Requirements for using M41-M44: frequency conversion and spindle automatic gearing is active. Change parameter NO.1 Bit4 and NO.10 Bit7 to 1. p. 270
If 180 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.
This page summarises what the manufacturer’s manual says about 180; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.