Tool change is not ready because tool number does not match current tool number. The manual's first action is: “Press reset key to cancel the alarm or adjust position of signal sending disk, or according to the state of NO.2 T01-T08, adjust NO.9 Bit1 level setting or change NO.10 Bit2 to 0: Shield tool number detection signal.”
- Model
- GSK GSK980TB3
- Display shows
- 187
- Type
- Alarm code
- Source
- Manual p. 270
What 187 means
Tool changing is not ready. Tool number is not consistent with the current tool number. p. 270
Common causes
- Tool changing is not ready. Tool number is not consistent with the current tool number. p. 270
What to do
- Press reset key to cancel the alarm or adjust position of signal sending disk, or according to the state of NO.2 T01-T08, adjust NO.9 Bit1 level setting or change NO.10 Bit2 to 0: Shield tool number detection signal. p. 270
If 187 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.
This page summarises what the manufacturer’s manual says about 187; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.