GSK GS2000T Series Error Err-18: No braking feedback corresponds to braking enable signal

AC servo drive unit · taken from the manufacturer’s manual, pages cited

Fault codeErr-18

No braking feedback corresponds to braking enable signal because the braking circuit is faulty or braking resistance is excessive. The manual's first action is: “Change a servo drive unit.”

Model
GSK GS2000T Series
Display shows
No braking feedback corresponds to braking enable signal (Err-18)
Type
Fault code
Source
Manual p. 122

What Err-18 means

No braking feedback corresponds to braking enable signal p. 122

Common causes

  • Braking circuit fault; p. 122
  • Excessive braking resistance; p. 122

What to do

  1. Change a servo drive unit. p. 122
  2. Measure the braking resistance with a universal meter, and change a correct braking resistor. p. 122

If Err-18 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 122 All GS2000T Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Err-18; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.