GSK GS2000T Series Error Err-28: Software upgrading parameter error

AC servo drive unit · taken from the manufacturer’s manual, pages cited

Fault codeErr-28

Software upgrading parameter error occurs when parameters are not modified and saved after software recording or upgrading. The manual's first action is: “Restore the default parameters and re-power on after the parameters are saved.”

Model: GSK GS2000T Series
Display shows: Software upgrading parameter error (Err-28)
Type: Fault code
Source: Manual p. 122

Meaning
Common causes
What to do
Still not solved
Source

What Err-28 means

Software upgrading parameter error p. 122

Common causes

Parameters are not modified and saved after the software recording or upgrading. p. 122

What to do

Restore the default parameters and re-power on after the parameters are saved. p. 122

If Err-28 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 122 All GS2000T Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Err-28; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.