The start or stop angles for the inside source in the round tube template are invalid. The manual's first action is: “Change the start or stop angle for the inside source definition then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- INVALID START-STOP ANGLES FOR THE INSIDE SOURCE. (#1151)
- Type
- Error code
- Source
- Manual p. 432
What #1151 means
INVALID START-STOP ANGLES FOR THE INSIDE SOURCE. p. 432
Common causes
- The 'round tube' template description uses 'start' and 'stop' angles (in degrees) to define the limits of the inside source. Both negative and positive angle values are allowed. Positive angles are measured in the counterclockwise direction. The start angle should not be greater than the stop angle. p. 432
What to do
- Change the start or stop angle for the inside source definition then try again. p. 432
Before you service the product, read the safety instructions in the manual p. 526.
If #1151 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1151; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.