Two inner contour fragments with different material definitions are not joined at a shared node, which is required for valid boundary definition. The manual's first action is: “Two inner contour fragments are joined at a node of the inner contour. The above error message is generated if a boundary fragment is not joined at the node where two inner contour fragments with different materials are joined. Make sure you identify properly the coordinates for all the boundary fragments. Then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #1128
- Type
- Error code
- Source
- Manual p. 430
What #1128 means
A BOUNDARY NODE IS EXPECTED BETWEEN TWO INNER CONTOUR FRAGMENTS WITH DIFFERENT MATERIAL DEFINITIONS. p. 430
Common causes
- A BOUNDARY NODE IS EXPECTED BETWEEN TWO INNER CONTOUR FRAGMENTS WITH DIFFERENT MATERIAL DEFINITIONS. p. 430
What to do
- Two inner contour fragments are joined at a node of the inner contour. The above error message is generated if a boundary fragment is not joined at the node where two inner contour fragments with different materials are joined. Make sure you identify properly the coordinates for all the boundary fragments. Then try again. p. 430
Before you service the product, read the safety instructions in the manual p. 526.
If #1128 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1128; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.