The outer contour has a discontinuity where fragments do not connect end-to-end forming a continuous polygonal line. The manual's first action is: “It is required that all fragments of the outer contour must be joined end to end making up a continuous polygonal line that starts and ends on the beaker symmetry axis. If it is not the case, the above error message appears. Change the erroneous fragment coordinates to fix the error. Then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #1126
- Type
- Error code
- Source
- Manual p. 430
What #1126 means
A DISCONTINUITY OF THE OUTER CONTOUR IS FOUND IN THE BEAKER DESCRIPTION FILE. p. 430
Common causes
- A DISCONTINUITY OF THE OUTER CONTOUR IS FOUND IN THE BEAKER DESCRIPTION FILE. p. 430
What to do
- It is required that all fragments of the outer contour must be joined end to end making up a continuous polygonal line that starts and ends on the beaker symmetry axis. If it is not the case, the above error message appears. Change the erroneous fragment coordinates to fix the error. Then try again. p. 430
Before you service the product, read the safety instructions in the manual p. 526.
If #1126 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1126; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.