Boundary fragments in the beaker description file contain both a material name and density, which is invalid. The manual's first action is: “Remove the material name and/or the density value from the boundary fragment contour definition.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #1110
- Type
- Error code
- Source
- Manual p. 428
What #1110 means
NEITHER A MATERIAL NAME NOR A DENSITY IS ALLOWED FOR A BOUNDARY FRAGMENT IN THE BEAKER DESCRIPTION FILE. p. 428
Common causes
- The beaker description may contain fragments defining inner, outer, and boundary contours. Boundary fragments may be defined only at a contour node where fragments with two different materials join. Therefore, neither a material name nor a density value is allowed in the definition of a boundary fragment. p. 428
What to do
- Remove the material name and/or the density value from the boundary fragment contour definition. p. 428
Before you service the product, read the safety instructions in the manual p. 526.
If #1110 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1110; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.