Industrial

PSD835G2 is a configurable memory system on a chip for 8-bit microcontrollers.

ST92185B 16K/24K/32K ROM HCMOS MCU WITH ON-SCREEN-DISPLAY is a highly integrated 8/16-bit microcontroller from ST company, with 8/16-bit register file, RUN, WFI, SLOW and HALT modes, operating temperature range of 0°C to +70°C, up to 24 MHz operation (at 5V±10% voltage), 16, 24 or 32 Kbytes of ROM, 256 bytes of register file (accumulators or index registers) RAM, 256 bytes of on-chip static RAM, 2K bytes of TDSRAM (Display Storage RAM) and 28 fully programmable I/O pins.

ST7MC1/ST7MC2 is an 8-bit MCU launched by ST company, which has nested interrupts, flash, 10-bit ADC, brushless motor control, five timers, SPI, LINSCI® and other functions.

The LM101A, LM201A, and LM301A are high-performance operational amplifiers featuring very low input bias current and input offset voltage and current to improve the accuracy of high-impedance circuits using these devices. The high common-mode input voltage range and the absence of latch-up make these amplifiers ideal for voltage-follower applications. The devices are protected to withstand short circuits at the output. The external compensation of these amplifiers allows the changing of the frequency response (when the closed-loop gain is greater than unity) for applications requiring wider bandwidth or higher slew rate. A potentiometer may be connected between the offset-null inputs (N1 and N).

The LK112S is a low dropout linear regulator with a built-in electronic switch. The internal switch can be controlled by TTL or CMOS logic levels. The device is ON state when the control pin is pulled to a logic high level. An external capacitor can be used connected to the noise bypass pin to lower the output noise level to 30µVrms. An internal PNP pass transistor is used to achieve a low dropout voltage. The LK112S has a very low quiescent current in ON MODE while in OFF MODE the Iq is reduced down to 100nA max. The internal thermal shutdown circuitry limits the junction temperature to below 150°C. The load current is internally monitored and the device will shutdown in the presence of a short circuit or overcurrent condition at the output.

AD5165 is a ultralow power digital potentiometer from Analog Devices, with a working voltage of 1.8V, a maximum resistance of 100kΩ and supports 256 positions, suitable for battery powered electronic devices, remote utility meter adjustment, mechanical potentiometer replacement, transducer circuit adjustment, automotive electronic equipment adjustment, gain control and offset adjustment, system calibration, VCXO adjustment and other applications.

The AD5251/AD5252 are dual 64/256-position I2C nonvolatile memory digital potentiometers with 1 kΩ, 10 kΩ, 50 kΩ, and 100 kΩ resistance ranges and nonvolatile memory that stores wiper setting with write protection.

AD5259 is a non-battery 256-position digital potentiometer from Analog Devices, features 256 positions, I2C-compatible interface, 5kΩ/10kΩ/50kΩ/100kΩ four resistance values, ±1% accuracy, ≤1ms EEPROM refresh time, 100 years typical data retention time, 3V~5V single power supply, etc., suitable for LCD panel VCOM adjustment, LCD panel brightness and contrast control, mechanical potentiometer replacement, programmable power supply, RF amplifier biasing, etc. applications

The AD5258 is a nonvolatile, I2C-compatible 64-position digital potentiometer with compact packaging and multiple features, suitable for applications such as LCD panel adjustment, power supply adjustment, and RF amplifier biasing.

The AD5290 is a high voltage, high performance digital potentiometer with 256 positions and resistance ranges of 10kΩ, 50kΩ, and 100kΩ. It can operate on a single supply of +20 V to +30 V or dual supplies of ±10 V to ±15 V. It utilizes the low temperature coefficient iCMOS™1 process technology and features a compact MSOP-10 package and automotive temperature range of -40°C to +125°C.

The AD5293 is a single-channel digital potentiometer with 1024-position resolution and 1% R-tolerance. It features a SPI-compatible serial interface and can be used as a replacement for mechanical potentiometers for applications such as gain and offset adjustment, programmable voltage-to-current conversion, programmable filters, delays, and time constants, as well as sensor calibration.

This document introduces the specifications and features of C&K Y Series 4, 5 and 6 Tumbler Switchlocks. The series offers anti-static switch design, multiple models and applications, including point-of-sale terminals, cash registers and computers.

The document describes the features and characteristics of XL Photonics, Inc.'s XPD0250CT-001 2.5 Gbps PIN-TIA module, including wide dynamic range, differential transimpedance, bandwidth, differential outputs, automatic gain control, etc.

XN0A312 is a NPN+PNP composite transistor produced by Toshiba. It is used in switching/digital circuits.