Industrial

The CNY17F is an optocoupler from Vishay that has no base connection, high common mode interference immunity, and long term stability.

SLLS177G is a programmable auto-RTS and auto-CTS device with multiple modes and features. It supports CTS control of the transmitter and RTS control of the RCV FIFO contents and threshold. It can directly drive an RJ11 cable and is compatible with existing TL16C450 software. The device operates at high clock rates and has a programmable baud rate generator for high-speed operation. It also features complete status reporting capabilities and programmable serial interface characteristics.

The LTC1099 is a high speed microprocessor compatible 8-bit analog-to-digital converter (A/D) from Linear Technology Corporation. It has a conversion rate of 2.5µs and can sample input signals up to 156kHz 5VP-P.

The MAX8516/MAX8517/MAX8518 is a low-dropout linear regulator that operates from input voltages as low as 1.425V and is able to deliver up to 1A of continuous output current with a maximum dropout voltage of only 200mV. The output voltage can be set from 0.5V to (VIN - 0.2V) and is 1.4% accurate over load and line variations, from 0°C to +85°C. These regulators use small, 1µF ceramic input capacitors and 4.7µF ceramic output capacitors to deliver 1A output current. High bandwidth provides excellent transient response and limits the output voltage deviation to 45mV for a 20mA to 1A load step, with only a 4.7µF ceramic output capacitor, and the voltage deviations can be reduced further by increasing the output capacitor. Designed with an internal p-channel MOSFET pass transistor, the MAX8516/MAX8517/MAX8518 feature low 340µA (typ) supply current during dropout conditions. Soft-start reduces inrush current. Other features include a logic-controlled shutdown mode, short-circuit protection, and thermal-overload protection. The MAX8517 features a power-OK (POK) output that transitions high when the regulator output is within ±10% of its nominal output voltage. The MAX8518 features a 150ms power-on reset output. The parts are packaged in a 10-pin µMAX® package that includes an exposed pad for optimal power dissipation.

HUBER+SUHNER QMA is a subminiature connector with 50Ω impedance. The frequency range extends to 18 GHz, but most QMA connectors are Return Loss optimized for frequencies up to 6 GHz. The interface is based on the SMA dimension, but uses a new snap-lock mechanism for coupling. The QMA interface offers similar performance to SMA, but with an easier, faster, and safer coupling operation. The packaging density of QMA is increased compared to SMA connectors. QMA is not intermateable with SMA.

AD9866 is a low cost 3.3V CMOS MxFE from Analog Devices for broadband modems, with 12-bit DAC, 2×/4× interpolation filter, 200 MSPS DAC update rate, integrated 23 dBm line driver with 19.5 dB gain control, 12-bit, 80 MSPS ADC, -12 dB to +48 dB low noise RxPGA (<2.5 nV/√Hz), third order programmable low-pass filter, flexible digital data path interface, half- and full-duplex operation, backward compatible with AD9975 and AD9876, various power-down/reduction modes, internal clock multiplier (PLL), 2 auxiliary programmable clock outputs, available in 64-lead chip scale package or bare die

LMC7215/LMC7225 Micro-Power, Rail-to-Rail CMOS Comparators with Push-Pull/Open-Drain Outputs and TinyPak™ Package

The ICL7667 is a dual monolithic high-speed driver designed to convert TTL level signals into high current outputs at voltages up to 15V. Its high speed and current output enable it to drive large capacitive loads with high slew rates and low propagation delays. With an output voltage swing only millivolts less than the supply voltage and a maximum supply voltage of 15V, the ICL7667 is well suited for driving power MOSFETs in high frequency switched- mode power converters. The ICL7667’s high current outputs minimize power losses in the power MOSFETs by rapidly charging and discharging the gate capacitance. The ICL7667’s inputs are TTL compatible and can be directly driven by common pulse-width modulation control ICs.

PolySwitch™ PPTC is a resettable thermal element used in a wide range of electronic products, including automotive, battery and portable electronics. It is a nonlinear thermistor that limits dangerous high currents under fault conditions. This device can be repeatedly reset and does not require replacement. To date, billions of PolySwitch products have been used to protect a wide range of electronic products.

TL16C750 is a 64-byte FIFO and auto-flow control asynchronous communications element produced by Texas Instruments.

MC33501, MC33503 1.0 V, Rail−to−Rail, Single Operational Amplifiers The product is a single supply operational amplifier that provides rail−to−Rail operation on both the input and output, and the output voltage can swing within 50 mV of each power rail. It has high input impedance, high output current and low input offset

The K3010P/ K3010PG series is an optocoupler product with a phototriac output of 250 V VDRM. The product features isolation materials according to UL 94-VO, pollution degree 2, and a climatic classification of 55/100/21. Its special construction provides a low coupling capacity and high common mode rejection. Additionally, the product is compliant with RoHS standards and has high insulation strength and creepage current resistance.

The FAN7527B is a simple and high-performance active power factor correction controller, optimized for electronic ballasts and low power, high-density power supplies. It features an internal start-up timer, internal R/C filter, precise adjustable output overvoltage protection, zero current detector, etc.

The ADP3118 is a dual high voltage MOSFET driver optimized for driving two N-channel MOSFETs, which are the two switches in a nonisolated synchronous buck power converter. Each of the drivers is capable of driving a 3000 pF load with a 25 ns propagation delay and a 25 ns transition time. One of the drivers can be bootstrapped and is designed to handle the high voltage slew rate associated with the nonisolated synchronous buck power converter.

LT3080 1 3080f Adjustable 1.1A Single Resistor Low Dropout Regulator