Industrial

STBS06H - STBS5D0 is a bidirectional transient voltage suppressor from ST company, with 500W surge capability, excellent clamping capability, low zener impedance, fast response time, typical IR less than 1µA above 10V

STP15NK50Z, STP15NK50ZFP, STB15NK50Z, STB15NK50Z-1, STW15NK50Z is a high voltage MOSFET launched by ST. Its feature is RDS(on) as low as 0.30 ohm, which is very suitable for applications with high switching speed and high current requirements, such as for offline power supplies, adapters, PFC and lighting

The document describes the features and characteristics of several capacitor diode products from Microsemi.

HIN202, HIN206, HIN207, HIN208, HIN211, HIN213 are a family of RS-232 transmitters/receivers interface circuits that are powered by a single +5V power supply and meet all EIA RS-232E and V.28 specifications. They are particularly suited for applications where ±12V is not available. The family of devices offers a wide variety of RS-232 transmitter/receiver combinations to accommodate various applications (see Selection Table). The HIN206, HIN211 and HIN213 feature a low power shutdown mode to conserve energy in battery powered applications. In addition, the HIN213 provides two active receivers in shutdown mode allowing for easy “wakeup” capability. The drivers feature true TTL/CMOS input compatibility, slew rate-limited output, and 300Ω power-off source impedance. The receivers can handle up to ±30V input, and have a 3kΩ to 7kΩ input impedance. The receivers also feature hysteresis to greatly improve noise rejection. Applications • Any System Requiring RS-232 Communications Port - Computer - Portable, Mainframe, Laptop - Peripheral - Printers and Terminals - Instrumentation - Modems Features • Meets All RS-232E and V.28 Specifications • Requires Only 0.1µF or Greater External Capacitors • High Data Rate.

This document describes the electrical specifications and features of the Sumlink ST-85540 1CT:1 model. The product is a single and dual transformer module for ITU G.703 codirectional interface, providing a minimum isolation of 1500 Vrms. It features a 64 KBPS interface transformer, matched to the integrated circuit, and operates within a temperature range of 0°C to 70°C.

This application note summarizes the differences between ATmega48, ATmega88 and ATmega168. Refer to the datasheets for detailed information on the devices.

This document describes a high-performance, low-power AVR 8-bit microcontroller with advanced RISC architecture and various features, including high endurance non-volatile memory, multiple peripheral features, and special microcontroller features.

This document describes the specifications and dimensions of the C&K Y Series 4, 5, and 6 tumbler switchlocks. These switchlocks feature anti-static properties, momentary models, and options for wire leads and harnesses. Typical applications include point-of-sale terminals, cash registers, and computers.

The AT24HC02B is a serial electrically erasable and programmable read-only memory (EEPROM) with hardware data protection, organized as 256 words of 8 bits each. This product is optimized for low-power and low-voltage operation, suitable for industrial and commercial applications. It supports voltage range from 1.8V to 5.5V, and accessed via a two-wire serial interface.

The U443/U444 N-Channel JFET Monolithic Dual is designed for high speed amplifier circuits. Featuring high gain ( > 6 mS typical), low leakage (< 1pA typical) and low noise this device is an excellent choice for high performance test and measurement, wideband amplifiers and VHF/UHF circuits.

The XR-2207 is a monolithic voltage-controlled oscillator (VCO) integrated circuit featuring excellent frequency stability and a wide tuning range. It provides simultaneous triangle and squarewave outputs over a frequency range of 0.01Hz to 1MHz. It is ideally suited for FM, FSK, and sweep or tone generation, as well as for phase-locked loop applications.

LET9060C is an N-Channel enhancement-mode lateral Field-Effect RF power transistor, designed for high gain broadband, commercial and industrial applications. It operates at 28 V in common source mode at frequencies up to 1.0 GHz. LET9060C boasts the excellent gain, linearity and reliability of the ST latest LDMOS technology. Its superior performances make it an ideal solution for base station applications.

CD4017BC/CD4022BC is a 5/4 stage divider.